User mistakes, tired batteries, loose sensors and drafts are common causes of false alarms, and nearly all of them can be prevented with a few habits and a service visit. In Reno a false intrusion alarm costs $98, so a system that cries wolf gets expensive.
Key points
- Sparks Police say about 98% of the burglar alarms they respond to are false.
- Reno charges $98 for a false intrusion alarm and $265 for a false robbery, duress or panic alarm.
- Reno can suspend a permit after three or more burglar false alarms in a permit year.
- Better panel settings are part of the fix: a standard exists for false alarm reduction features.
- Unwanted fire alarms are a code violation in Washoe County's fire code.
- Keep your call list current, because answering the center's call quickly is the simplest fix of all.

A false alarm is an alarm that sends help when nothing is wrong. It costs you a fee, it takes an officer away from something else, and over time it teaches everyone to take your alarm less seriously. The good news is that false alarms are mostly a design and habit problem, and both can be fixed.
Why it matters
The Sparks Police page on alarm permits says officers handle almost 4,000 false alarm calls a year, and that about 98% of the burglar alarms they respond to turn out to be false. We cannot say how that compares with other agencies, but it shows the scale.
Reno puts a price on it. The city's fiscal year 2026/27 schedule lists $98 for a false intrusion alarm and $265 for a false robbery, duress or panic alarm, and its permit rules allow suspension after three or more burglar false alarms in a permit year. The city's fee schedule does not describe any false alarm as free.
The usual causes, and the fix for each
Nuisance alarms sort into a short list of causes, shown in the table.
| Cause | What happens | Fix |
|---|---|---|
| Wrong code or forgotten exit | Someone enters, panics, and the siren runs | Practice the code with everyone and learn how long the entry delay lasts |
| Door not fully latched | Wind or a loose latch trips the contact | Realign the door and contact, or adjust the strike |
| Pets and motion sensors | A cat or dog crosses the detection zone | Reposition the sensor or use a pet-aware model; a technician can aim it |
| Moving air or hot spots | Space heaters, vents and ceiling fans move heat past the sensor | Move the sensor away from vents and radiators |
| Low battery | Panel or sensor power dips and reports a fault | Replace batteries when the keypad first says so |
| Weak communicator signal | A signal gets garbled or repeats | Have the communicator checked; see cellular and IP communicators |
Notice that very few of these involve a burglar. That is the point: the fix is usually in the house, not in the alarm company's office.
Setup choices that cut false alarms
The Security Industry Association publishes ANSI/SIA CP-01, a control panel standard of features meant to reduce false alarms, with a 2019 revision. It covers how a panel recognizes events, handles information and lays out the system. Ask whether the panel you have follows it, and which settings are turned on. The SIA standard page describes what it covers.
Other setup decisions help too. Give every household member and every cleaner, dog walker or contractor their own code, so you can tell who set it off. Keep the entry delay long enough to reach the keypad without rushing. Put motion sensors where a person would walk, not where a curtain moves.
When it goes off anyway
- Enter your code at the keypad to silence the siren. Do this before anything else.
- Answer the central station's call, give your passcode, and say it is a mistake. They will tell you what they have logged.
- Write down the time and what you were doing. A pattern across three alarms points to a sensor, not to bad luck.
- Call us for a service visit if the same sensor or door trips twice. Our alarm repair and service page explains how we approach it.
Fire alarms count too
Fire systems have their own version of the problem. Washoe County's Chapter 60 fire code says unwanted fire alarms are a violation of the code and that owners must maintain their systems and train the people who use the building. Steam from a shower or cooking smoke are frequent triggers for smoke detectors, so location matters as much as cleaning. We cover the testing side on our fire alarm inspection page.
A burglar alarm service call is a good time to ask about the permit as well. Our Reno alarm permit guide lists every fee.
Sources (4)
- sparksnv.gov: sparksnv.gov/police/i_want_to/obtain_alarm_ordinance_information.php (checked November 2026)
- City of Reno: reno.gov/Documents/Police/Bureaus/Support%20Services%20Bureau/Records%20Section/PDOnlyAdop (checked November 2026)
- securityindustry.org: securityindustry.org/industry-standards/ansi-sia-cp-01/ (checked November 2026)
- Truckee Meadows Fire Protection District: tmfpd.us/wp-content/uploads/2026/01/Ordinance-Clean-Copy-Chapter-60-Fire-Prevention-and-Pr (checked November 2026)

